Getting Started

This chapter provides the basic information to get started with ROS2 on your ComboFox platform.

Network Connection

By default your ComboFox platform will try to connect to the wireless network combofox.

First power up the WiFi access point included and wait until the network ComboFox is available. Optionally connect the access point to your company/home network via ethernet to enable internet access on the platform when needed.

Next you may connect your PC to ComboFox too, the password can be found on the access point’s exterior.

The IP-Address of your mobile platform is 192.168.1.10. Once the platform has booted and your PC is connected to ComboFox you can connect to the platform using:

  • SSH

Bringup ComboFox

Please follows the following steps to turn on ComboFox platform:

  1. Power up Wifi access

  2. Turning on the key selector

  3. Reset by clicking the reset button three times

  4. You are ready to command ComboFox

  5. Next step is to map the environment

Warning

By turning on ComboFox with the key selector, a startup operation will launch the appropriate controllers, actions, topics, and services. Wheel homing and awtube arm pairing will be performed.

If everything goes well go from your preferred browser to http://192.168.1.10:8080 to see the state of the robot.